washer fluid for fast & effective
defrosting & cleaning!
Heated Wash is made in the USA!
The Revolutionary Unit for
Just by using your windshield washers!
Great for all Cars, SUVs & Light Trucks
Install two units for use on Heavy Trucks, Semi-Trucks & Buses
Unit works with virtually all
existing washer / wiper systems
The Alpha Therm Heated Wash is
presently the only proven, effective windshield washer fluid heating system that
offers consumers both safety and convenience at an affordable price.
The Alpha Therm Heated Wash patented, and proprietary technology enables its
heating system to heat windshield
washer fluid using a minimal amount of energy produced by the vehicle’s
electrical system to remove frost, ice,
snow, bugs, glare and other debris.
The Heated Wash has been proven to be safe and effective in tests
on all types of windshield glass and in many environments.
Get ready to see the difference when you
install the AlphaTherm Windshield Washer Heater. By
heating your wiper fluid to over 125 degrees F, the
AlphaTherm Washer Fluid Heater sprays your
windshield with a super-heated mist of fluid for
Once installed, the AlphaTherm unit works in
conjunction with your factory washer spray. Just
activate the spray control and the heated fluid
mists your windshield to clear ice and frost in
winter - bugs and road grime in summer.
The AlphaTherm Windshield Washer Heater bolts easily
in your engine compartment and utilizes the fluid in
your factory washer reservoir. Powered by your
vehicle’s electrical system, the washer fluid heater
uses very little energy, yet is always ready to mist
your windscreen with heated fluid.
The heated fluid also helps preserve the life and
bolsters the effectiveness of your wiper blades.
Plus, it unblocks frozen or clogged spray nozzles
and keeps them clear for maximum coverage. Best yet,
AlphaTherm backs your Windshield Washer Heater with
a frost-free 1-year warranty.
Heated Wash AT-38OD
operates in “On-Demand” mode.
The unit starts to operate when the ignition is on (engine running) and
battery voltage level
is higher than 13.0 volts. Once the unit is activated, the washer fluid
inside its heating
chamber will be heated and kept within pre-determined temperature limits
(125 – 135°F), so there is always hot fluid inside the unit’s heating
chamber which can be
used by a driver for cleaning the windshield.
Each time the driver activates the factory installed washer system,
heated washer fluid is
applied to the windshield for approximately the first 3 seconds of
spray. Three seconds of
the spray delivers approx. 50-60 cc of fluid that is considered
sufficient amount of fluid for
one spray. The next portion of heated washer fluid is available in 10-20
on ambient conditions).
The Heated Wash unit uses full power of 50 Amps for 30 seconds to heat
the washer fluid
up to pre-determined temperature limits (125 – 135°F), and minimal power
to keep it
within these limits. The unit’s power consumption is less than 2 Amps
Once the unit starts to operate (engine is running), it will heat the
washer fluid in
approximately 30 seconds; driver operates the washer system manually to
heated washer fluid onto the windshield. Recommended duration of spray
is 3 seconds.
Driver can spray as many times as he wants. Best results are achieved
intervals between sprays are approx. 20 seconds.